Nebula 20.00 & SCR50AXE - Difficulties with 2.4 GHz

Options
2»

All Replies

  • Zyxel_Judy
    Zyxel_Judy Posts: 2,789
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - Nebula
    image  Zyxel Employee
    Options
    https://community.zyxel.com/en/discussion/comment/85483#Comment_85483

    Please use the generated IP address and port on the TeraTerm, PuTTY to SSH, not for browser.

    image.png image.png

    Zyxel_Judy

  • GiuseppeR
    GiuseppeR Posts: 782
    Zyxel Certified Network Engineer Level 1 - Switch Zyxel Certified Network Engineer Level 1 - Nebula 500 Comments 5 Answers
    image  Guru Member
    edited June 10
    Options

    Hi @Zyxel_Judy

    sorry my bad, I did not read the line below in the screenshot 😎

    Anyway command not working:

    immagine.png

    Not found also with "show ?" in command line.

  • Zyxel_Judy
    Zyxel_Judy Posts: 2,789
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - Nebula
    image  Zyxel Employee
    Options

    Hi @GiuseppeR

    Could you share the Nebula organization & site name and enable Zyxel Support for our checking?

    Zyxel_Judy

  • GiuseppeR
    GiuseppeR Posts: 782
    Zyxel Certified Network Engineer Level 1 - Switch Zyxel Certified Network Engineer Level 1 - Nebula 500 Comments 5 Answers
    image  Guru Member
    Options

    Hi @Zyxel_Judy

    sent details via PM, also to understand why the command was not working properly.

    I'm at your disposal, see you soon

  • Zyxel_Judy
    Zyxel_Judy Posts: 2,789
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - Nebula
    image  Zyxel Employee
    Options

    As our private message, please ignore the CLI steps for viewing wireless clients on the SCR50AXE that we shared above — that was for the USG LITE60AX. To view wireless clients on the SCR50AXE, we need to access debug mode, which only we have the privilege to do.

    In case you go onsite to do a LAN scan or take any steps to confirm the IoT bridge is connecting to the CiscoMaster24 SSID, please let us know and we can continue to help you.

    Zyxel_Judy

Categories

Nebula Tips & Tricks


    Read more

    Nebula Help Center

    EnglishTiếng ViệtРусскийไทย中文（台灣）