Zyxel nas542 boot loop after installing OMV
All Replies
-
the image is the one shared by you https://zyxel.diskstation.eu/Users/Mijzelf/NAS/542/and it has 6.99 MB, i rename it to uImage.520.bin from uImage.520ABAG1C0.bin0
-
That should be right. Maybe the load address is the problem. Try something else, like 82000000 or 2000000.
0 -
So, i made some progress using the bellow commands:
eth0.ipaddr=192.168.1.191
eth0.serverip=192.168.1.139
addpart /dev/mem [email protected](kernelraw)
addpart /dev/mem [email protected](kernel)
netload="/dev/mem.kernel"
tftp uImage.520.bin $netload
bootm ${netload}
It boots from the image but in the end, after restart i get bad magic number. Looking on this thread https://community.zyxel.com/en/discussion/7674/nas542-bootloop-after-debian-omv-get-a-new-firmware-solved/p4 i can see that some bootargs was modified on the config file, can you please help me with what i need to modify on the config file?0 -
faierbol said:It boots from the image but in the end, after restart i get bad magic number.
0
Categories
- 6.9K All Categories
- 2 Education Center
- 1.4K Nebula
- 34 Nebula Ideas
- 40 Nebula Status and Incidents
- 3.9K Security
- 203 Security Ideas
- 750 Switch
- 31 Switch Ideas
- 627 WirelessLAN
- 9 WLAN Ideas
- 4.6K Consumer Product
- 105 Service & License
- 223 News and Release
- 39 Security Advisories
- 520 FAQ
- 238 Nebula FAQ
- 120 Security FAQ
- 73 Switch FAQ
- 67 WirelessLAN FAQ
- 6 Consumer Product FAQ
- Documents
- 30 Nebula Monthly Express
- 44 About Community
- 32 Security Highlight
Consumer Product Help Center
