Zyxel nas542 boot loop after installing OMV
All Replies
-
the image is the one shared by you https://zyxel.diskstation.eu/Users/Mijzelf/NAS/542/and it has 6.99 MB, i rename it to uImage.520.bin from uImage.520ABAG1C0.bin0
-
That should be right. Maybe the load address is the problem. Try something else, like 82000000 or 2000000.
0 -
So, i made some progress using the bellow commands:
eth0.ipaddr=192.168.1.191
eth0.serverip=192.168.1.139
addpart /dev/mem 8M@0x8000(kernelraw)
addpart /dev/mem 8M@8M(kernel)
netload="/dev/mem.kernel"
tftp uImage.520.bin $netload
bootm ${netload}
It boots from the image but in the end, after restart i get bad magic number. Looking on this thread https://community.zyxel.com/en/discussion/7674/nas542-bootloop-after-debian-omv-get-a-new-firmware-solved/p4 i can see that some bootargs was modified on the config file, can you please help me with what i need to modify on the config file?1 -
faierbol said:It boots from the image but in the end, after restart i get bad magic number.
0
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 115 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 64 Switch Ideas
- 900 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 831 Nebula FAQ
- 401 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight