NSA310 stuck in boot loop
Sandesh_Kumar
Posts: 1 Freshman Member
Hi,
I have a NSA310 that has worked fine over the past few years. It is now constantly stuck in a boot loop ( I am not aware of any manual firmware upgrade). When switching on, the SYS light flashes green for a while, and then all the lights turn GREEN and stay on for a while, These all go off and SYS light then flashes green for a while further and this sequence continues over and over again
Please can you tell me how do i get my NAS to work again, I have tried a full reset using the reset button at the back of the unit but this has not helped
Regards
Sandesh
#NAS_Aug
I have a NSA310 that has worked fine over the past few years. It is now constantly stuck in a boot loop ( I am not aware of any manual firmware upgrade). When switching on, the SYS light flashes green for a while, and then all the lights turn GREEN and stay on for a while, These all go off and SYS light then flashes green for a while further and this sequence continues over and over again
Please can you tell me how do i get my NAS to work again, I have tried a full reset using the reset button at the back of the unit but this has not helped
Regards
Sandesh
#NAS_Aug
0
All Replies
-
Does it also reboot if you start it without disk?
0
Categories
- All Categories
- 415 Beta Program
- 2.4K Nebula
- 153 Nebula Ideas
- 100 Nebula Status and Incidents
- 5.7K Security
- 280 USG FLEX H Series
- 277 Security Ideas
- 1.4K Switch
- 74 Switch Ideas
- 1.1K Wireless
- 42 Wireless Ideas
- 6.4K Consumer Product
- 250 Service & License
- 395 News and Release
- 85 Security Advisories
- 29 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.6K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 75 Security Highlight