NSA310 stuck in boot loop
Options
Sandesh_Kumar
Posts: 1 Freshman Member
Hi,
I have a NSA310 that has worked fine over the past few years. It is now constantly stuck in a boot loop ( I am not aware of any manual firmware upgrade). When switching on, the SYS light flashes green for a while, and then all the lights turn GREEN and stay on for a while, These all go off and SYS light then flashes green for a while further and this sequence continues over and over again
Please can you tell me how do i get my NAS to work again, I have tried a full reset using the reset button at the back of the unit but this has not helped
Regards
Sandesh
#NAS_Aug
I have a NSA310 that has worked fine over the past few years. It is now constantly stuck in a boot loop ( I am not aware of any manual firmware upgrade). When switching on, the SYS light flashes green for a while, and then all the lights turn GREEN and stay on for a while, These all go off and SYS light then flashes green for a while further and this sequence continues over and over again
Please can you tell me how do i get my NAS to work again, I have tried a full reset using the reset button at the back of the unit but this has not helped
Regards
Sandesh
#NAS_Aug
0
All Replies
-
Does it also reboot if you start it without disk?
0
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 79 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 909 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 898 Nebula FAQ
- 415 Security FAQ
- 234 Switch FAQ
- 205 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight