[NEBULA] How to use NAT mode on AP?

Zyxel_Joslyn

Where to find: Configure > Access point > SSID advanced settings > Traffic options

Function description: NAT mode is used to have the AP create a DHCP subnet with its own NAT for the SSID. Provide minimum hardware requirement for Wi-Fi of small shop/café

If AP management IP address is NOT part of “10.0.0.0/8”, SSID subnet becomes “10.0.0.0/8”.

If AP management IP address is part of “10.0.0.0/8”, SSID subnet becomes “172.16.0.0/12”

Scenario: Enable NAT mode on the SSID which is provided for Guest usage.

Configuration: 
1. Go to Configure > Access points> SSID settings. Add to SSID as "Wi-Fi". Then click "Edit".

Or Configure > Access points > SSID advanced settings then select the SSID to continuing the setting.

2. Configure the Traffic options, enable "NAT mode" and click "Back"


3. Click "Save".



Successful Log.


Note. 
1. The following AP features do not work when NAT mode is on.
    a. 802.11r
    b. Layer2 isolation
    c. Dynamic VLAN (cloud authentication, RADIUS server)
2. When NAT mode is enabled on non-supported models, Nebula CC does not show any error message. And non-supported models disable any SSID with NAT mode enabled.

3. The IP address lease time is 8 hours.
4. List of access points supporting DHCP & NAT:  NWA50AX, NWA50AX PRO, NWA55AXE, NWA90AX, NWA90AX PRO, NWA110AX, NWA210AX, NWA220AX-6E, NWA1123-AC HD, NWA1123ACv3, NWA1302-AC, NWA5123-AC HD, WAC500, WAC500H, WAC5302D-Sv2, WAC6303D-S, WAX300H, WAX510D, WAX610D, WAX620D-6E, WAX630S, WAX640S-6E, WAX650S, WAX655E