How to load the drives of NAS325 into NAS326?
GaryHsu
Posts: 1 
Freshman Member
Freshman Member
I had a NAS325 but got no work last week. Then I buy one new NAS326 (since NAS325 is EOL) and move the drives from NAS325 to NAS326. But NAS326 can not recognize the drives, how can I do for this case?
And I also can not connect to NAS326 through web, is it normal? (I can see the NAS326 by NAS starter utility but nothing can do further.)
#NAS_June
And I also can not connect to NAS326 through web, is it normal? (I can see the NAS326 by NAS starter utility but nothing can do further.)
#NAS_June
0
All Replies
-
But NAS326 can not recognize the drives, how can I do for this case?
Unfortunately the disk layout of firmware 4 and lower is no longer supported/recognized by firmware 5 devices.
If you had a raid1 array, it's possible to do a poor man's conversion. Put one disk in the 326, and create a single disk raid1 volume. Then plugin the second disk, enable the ssh daemon, login over ssh, and assemble the (degraded) array on the second disk manually, and mount it. Then copy the contents of the old volume to the new volume. And finally add the 2nd disk to the new volume.
This involves copying all your data twice, and so it's time consuming.
0
Guru MemberCategories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 907 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
Consumer Product Help Center
FAQ