Data loss

lacc47
Posts: 4
Freshman Member

NAS326
I wanted to access my drives so I removed the drives from the nas. It is possible, that I took them back reversed, but It is not probable. Anyway, I cant access my drives. NAS turns off after boot beep. Without the drives it boots and it is accessible, but with the drives it turns always off. How can I repair this error?
There was no raid, it was two independent disk.
thanks
#NAS_Aug_2019
I wanted to access my drives so I removed the drives from the nas. It is possible, that I took them back reversed, but It is not probable. Anyway, I cant access my drives. NAS turns off after boot beep. Without the drives it boots and it is accessible, but with the drives it turns always off. How can I repair this error?
There was no raid, it was two independent disk.
thanks
#NAS_Aug_2019
0
All Replies
-
It doesn't matter when you exchanged the disks. The disks are recognized by their raid header (which is also available on a single disk layout).Try the disks one by one. I think one of them died.0
-
Hi,
Many thanks for answer.
I made factory reset without the disks, and after that the problem is solved, just I lost my configuration. Nas runs up, I can access the disks as befor.
regards
0
Categories
- All Categories
- 417 Beta Program
- 2.5K Nebula
- 160 Nebula Ideas
- 108 Nebula Status and Incidents
- 5.9K Security
- 331 USG FLEX H Series
- 286 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 259 Service & License
- 402 News and Release
- 86 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.8K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 80 Security Highlight