No signal detected on node 2 during “Location check” - what to do?
Options
TCordth
Posts: 3 Freshman Member
I have installed node 1 of a Zyxel Multy U succesfully. When I add node 2 i get the following issue. I get all the way to the step where node 1 and 2 are synced, but when i get to the “Check location” step it never detects a signal and i am not able to finish the installation. I have tried with factory reset but I always get stucked in
this step. I have also tried to move the two nodes close to each other without any luck. Have any of you experienced this problem and what is the solution?
#MultyU_Feb_2020
this step. I have also tried to move the two nodes close to each other without any luck. Have any of you experienced this problem and what is the solution?
#MultyU_Feb_2020
0
Accepted Solution
-
Have you tried to switch the primary Multy and second Multy?
You can install the second Multy as the Primary Multy, then add the other Multy.
1
All Replies
-
Have you tried to switch the primary Multy and second Multy?
You can install the second Multy as the Primary Multy, then add the other Multy.
1 -
The switch solved the problem, thanks!!!0
Categories
- All Categories
- 392 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 78 Nebula Status and Incidents
- 5.1K Security
- 51 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 332 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 880 Nebula FAQ
- 415 Security FAQ
- 220 Switch FAQ
- 195 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 63 Security Highlight