LTE7460-M608 Bridge Mode NAT?

FredD
FredD Posts: 2  Freshman Member
edited January 4 in Mobile Broadband
Hi,

I have my device in bridge mode, when I traceroute I can see the device. This is unexpected. Causing a double NAT. Is there a way to disable NAT so my router does not see the LTE7460-M608? Running latest: V1.00(ABFR.4)C0.

Router = 192.168.1.0
LTE7460-M608 = 192.168.0.1

I can also access the LTE7460 menu's from my LAN without a static route proving that NAT must be enabled.

Thank you,

Fred

 

Comments

  • Zyxel_Support_CPE
    Zyxel_Support_CPE Posts: 188  Zyxel Employee
    Sixth Anniversary
    Hi FredD , when you switch LTE7460 to bridge mode and the NAT has disabled already. LTE7460 and DSL CPE have different bridge mode behavior as you saw. It's a design for user convenient access and manage LTE7460 that when LTE7460 switch to bridge mode it will create a iptable rule for only on LAN device which obtain IP address from WAN it could directly access LTE7460 LAN IP without setup static IP address. Otherwise, other LAN devices(which not obtain IP from WAN) unable access LTE7460 LAN IP unless these devices setup static IP address.
  • FredD
    FredD Posts: 2  Freshman Member
    That does make sense :smile:
    Thanks for the response.

Categories

Consumer Product Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）