Problem with NAS326
Fabio64
Posts: 2
Hi. Today I extracted my two hard disks from my NAS326 to read them via USB 3.0. I was unable to read them from Windows (hard disks are formatted as GPT). When I reinserted the discs, I could access the data the NAS began beeping continuously until I removed them. I tried to update the firmware to the latest version available and now I can't access the files on the disks anymore. How can I recover my data? Thank you
0
All Replies
-
Not recommend to pull out the disk while NAS power up.It may caused some problem to the disk.As I know, it could not read the file via the USB.Could you share what is the status of the disk on the NAS now?0
-
I removed the disks with the NAS turned off. I inserted only one (the disks are in RAID 1) and I see the base folders of the NAS (admin, video, audio, photos) even with some data inside, but I no longer see the "work" folder that I had personally created and where were the other data. I found this guide: https://kb.zyxel.com/KB/searchArticle!gwsViewDetail.action?articleOid=013308&lang=EN but I'm afraid of losing files following it. What do you mean with "status of the disk on the NAS"? Thank you so much!
0 -
Have a look in the shares menu to see if you can re-enable the 'work' share.
0 -
If you're able to see the files in the disk, you can check the permission of the file.
0
Freshman Member
Guru MemberCategories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 908 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
Consumer Product Help Center
FAQ