NR7101 No access to WAN using WiFi...
Bamse
Posts: 5 
Freshman Member
Freshman Member
Hi,
After a factory reset I am no longer able to connect to any WAN sites using a WiFi connection to my NR7101. Cabled connection works just fine. It is probably just something obvious I have missed, but cannot seem to figure out what it is.
Thanks!
After a factory reset I am no longer able to connect to any WAN sites using a WiFi connection to my NR7101. Cabled connection works just fine. It is probably just something obvious I have missed, but cannot seem to figure out what it is.
Thanks!
0
Accepted Solution
-
Hi Bamse,
Refer to the product description, "WiFi interface is used for local management purposes only."
https://www.zyxel.com/products_services/5G-New-Radio-Outdoor-Router-NR7101/specifications
Regards,
Bob1
Master Member
All Replies
-
Hi Bamse,
Refer to the product description, "WiFi interface is used for local management purposes only."
https://www.zyxel.com/products_services/5G-New-Radio-Outdoor-Router-NR7101/specifications
Regards,
Bob1
Categories
- All Categories
- 439 Beta Program
- 2.8K Nebula
- 199 Nebula Ideas
- 125 Nebula Status and Incidents
- 6.3K Security
- 492 USG FLEX H Series
- 322 Security Ideas
- 1.6K Switch
- 83 Switch Ideas
- 1.3K Wireless
- 47 Wireless Ideas
- 6.8K Consumer Product
- 285 Service & License
- 455 News and Release
- 89 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.3K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 95 Security Highlight
