NSA-220 Plus - no HDD recognized anymore
SalziBen
Posts: 1
Hi!
I have an old NSA-220 Plus, started again a couple of weeks ago without any troubles.
2HDDs with 3 TB were running and data was stored as a backup. Then took it off the lan and power.
Some days ago I started it again and from this point on, the NAS wont find any hdds anymore. I tried to plug the HDDs in and out, even put in different other HDDs.
When starting, lights for System and HDDs are working normal and the NAS is found by the Zyxel-Software. But there is "no HDD" shown.
Does anybody have an idea?
Thx in advance and kr, Ben
I have an old NSA-220 Plus, started again a couple of weeks ago without any troubles.
2HDDs with 3 TB were running and data was stored as a backup. Then took it off the lan and power.
Some days ago I started it again and from this point on, the NAS wont find any hdds anymore. I tried to plug the HDDs in and out, even put in different other HDDs.
When starting, lights for System and HDDs are working normal and the NAS is found by the Zyxel-Software. But there is "no HDD" shown.
Does anybody have an idea?
Thx in advance and kr, Ben
0
All Replies
-
Check your powersupply. It might have not enough juice left to spin up the disks.
0 -
When you remove HDDs from your NAS do you feel the spinning of the hard drive platter?0
Guru Member
Freshman MemberCategories
- All Categories
- 431 Beta Program
- 2.6K Nebula
- 169 Nebula Ideas
- 114 Nebula Status and Incidents
- 6K Security
- 382 USG FLEX H Series
- 294 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.7K Consumer Product
- 267 Service & License
- 412 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.9K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 83 Security Highlight
