NR7101 does not accept Username and Password after factory reset

BrandSafway · June 20

Hi Zyxel Team,

i have setup a Zyxel NR7101 and upgraded it to the following device and modem module firmware successfully:

Router Firmware: 1.00(ABUV.5)C0
Modem Firmware: RG502QEAAAR11A07M4G

After having just changed some wifi settings it started to reset the WAN connection every 30 seconds and kept kicking me out of the configuration page due to "network change detected".

I then followed with a factory reset on the device. Pressing the button for 15 seconds.

Now im faced with the issue when i try to login via http://192.168.2.1/login

i keeps saying username or password wrong.

Username: admin

Password: 1234

i have also tried the default password that is printed on the label and worked with the initial setup. It run the factory set twice. Still facing the issue that the username/password is wrong.

I'm unable to login into the configuration page.

Please advise. Im unaware of any new default username/password shipping with the above firmware!

Regards!

SELBERG · June 20

Try a power off for a minute.

BrandSafway · June 22

thanks i tried that. in the end the problem was that the default password had an "a" that printed on the label looks like an "o". after factory reset it's accepting only the default password despite the guides saying after factory the default will be "1234"

NR7101 does not accept Username and Password after factory reset

All Replies

Categories

Consumer Product Help Center