ATP200 firmware update impossible
Options
Master Member
I have an ATP200 with the following fw versions installed in the flash:
Upgrade of any of these banks is impossible since either trying over FTP, or HTTP, after the upload of 532ABFW0C0.bin is finished, the serial console drops a Firmware not compatible! message.
Can you please advise how can I overcome this situation?
Upgrade of any of these banks is impossible since either trying over FTP, or HTTP, after the upload of 532ABFW0C0.bin is finished, the serial console drops a Firmware not compatible! message.
Can you please advise how can I overcome this situation?
0
All Replies
-
I have also tried with 5.30(ABFW.0) version, but the result was the same...0
-
Maybe try run standby firmware then update it?
0 -
Hi @Peppino,Please follow steps below to update firmware.1) Backup partition 2(current running partition) startup configuration file.2) Reboot on partition 1.(Switch running partition from 2 to 1)3) Update V5.32 firmware on partition 1.4) Apply 1) configuration file on partition 1.0
-
Thank you, it worked! What is causing this?Zyxel_Cooldia said:Hi @Peppino,Please follow steps below to update firmware.1) Backup partition 2(current running partition) startup configuration file.2) Reboot on partition 1.(Switch running partition from 2 to 1)3) Update V5.32 firmware on partition 1.4) Apply 1) configuration file on partition 1.0 -
0
Guru Member
Zyxel Employee
Categories
- All Categories
- 441 Beta Program
- 2.9K Nebula
- 209 Nebula Ideas
- 127 Nebula Status and Incidents
- 6.4K Security
- 534 USG FLEX H Series
- 338 Security Ideas
- 1.7K Switch
- 84 Switch Ideas
- 1.3K Wireless
- 51 Wireless Ideas
- 6.9K Consumer Product
- 295 Service & License
- 461 News and Release
- 90 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.7K FAQ
- 34 Documents
- 86 About Community
- 99 Security Highlight
