How to config WAN trunk in NCC webpage
Hello,
I see that using USGFLEX500 is useful to set which RJ45 port is WAN or LAN.
Looking into its config inside "Site-wide > Configure > Firewall > Routing" I see where I could set the WAN for backup: here I have the problem to set a WAN trunk, I have a WAN1 as main connection, but I want to use as a backup the WAN2 + WAN3.
Where I can config this on Nebula?
Thanks in advance
All Replies
-
Hi @GiuseppeR ,
Greeting Forum, Please knidly below the tutorial, It guide how to set WAN backup on Nebula
Please feel free to contact us if any concerns.
Thank you
0 -
Hello @Zyxel_Kevin
thanks for the tutorial but I have WAN1, WAN2, WAN3.
I need that when WAN1 fails, both WAN2 + WAN3 go online.
It seems to me that my scenario is not as described in the tutorial.
0 -
Hi @GiuseppeR ,
In general we will use Policy based route with Trunk interface when on-premise mode.
We don't support the kind of setting in Nebula so far.
We will continue enhace this part,
Thank you
0
Categories
- All Categories
- 397 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 91 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 918 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 920 Nebula FAQ
- 422 Security FAQ
- 237 Switch FAQ
- 208 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight