How to config WAN trunk in NCC webpage

GiuseppeR · October 2023

Hello,

I see that using USGFLEX500 is useful to set which RJ45 port is WAN or LAN.

Looking into its config inside "Site-wide > Configure > Firewall > Routing" I see where I could set the WAN for backup: here I have the problem to set a WAN trunk, I have a WAN1 as main connection, but I want to use as a backup the WAN2 + WAN3.

Where I can config this on Nebula?

Thanks in advance

Zyxel_Kevin · October 2023

Hi @GiuseppeR ,

Greeting Forum, Please knidly below the tutorial, It guide how to set WAN backup on Nebula

https://community.zyxel.com/en/discussion/14281/atp-flex-how-to-configure-wan-load-balancing-on-nebula

Please feel free to contact us if any concerns.

Thank you

GiuseppeR · October 2023

Hello @Zyxel_Kevin

thanks for the tutorial but I have WAN1, WAN2, WAN3.

I need that when WAN1 fails, both WAN2 + WAN3 go online.

It seems to me that my scenario is not as described in the tutorial.

Zyxel_Kevin · October 2023

Hi @GiuseppeR ,

In general we will use Policy based route with Trunk interface when on-premise mode.

We don't support the kind of setting in Nebula so far.

We will continue enhace this part,

Thank you

How to config WAN trunk in NCC webpage

All Replies

Categories

Nebula Tips & Tricks

Nebula Help Center