Configuring PPPoE with static IP issues
I’m trying to configure PPPoE over Nebula Zyxel on the Zyxel 100 Flex and I’m receiving issue on the form, that gateway is not matching IP address network.
When I’m entering this form there is already assigned IP address from different network. I’m deleting it and writing new one, but I think that the form is comparing gateway address to the initial IP address. Do you have idea how I can resolve it?
I was trying on a few different web browsers and it is always the same message :/
All Replies
-
original filling when I’m entering the form before I change to the target ip and gateway looks like in the attachment
0 -
Hi @Cnrd ,
I found your device already online at "2024-01-01T18:39:59.240Z", Did you resolve your issue ?
If not, Please kindly enable Zyxel Support Access then we will do the further checking.
Thank you
1 -
Hi @Zyxel_Kevin. The device is up and running, but it is working on dynamic IP now over NAT. When I want to change to PPPoE with static (before network provider will switch to the public IP) I cannot make it. I will invite support to help.
0 -
0
Categories
- All Categories
- 398 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 83 Nebula Status and Incidents
- 5.2K Security
- 99 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 922 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 212 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.1K FAQ
- 994 Nebula FAQ
- 445 Security FAQ
- 238 Switch FAQ
- 213 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 141 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight