NSA325-V2 Backup Planner

Ahhhh. Thank you. I was being very stupid. I was replacing the url in the web_prefix file

OK all sorted and backup is now working on the NSA325-V2 Thank you soooooooo much😁

OK so for idiots like me, this is what to do . . .

How to configure a an NSA325-V2 to act as an rsync target to back up a Synology NAS

1. Install the Mijzelf amazing wonderful repository 😊
   To do this . . .
   Make a txt file and put the following url in it
   http://zyxel.diskstation.eu/Users/Mijzelf/zypkg-repo/
   save it as "web_prefix" and make sure there is no file extention (no.txt)
   log into the Zxel nas on your web browser as admin
   go to Sharing - Shares
   Select the the admin Share and click on the Share Browser icon at the top
   click on the zy-pkgs folder icon to go into that folder
   Click on the Upload icon and upload the web_prefix file you just made
   Click close button at the bottom
   Go to Firmware/Packages and click on the Package tab
   Click on the Retrieve List from internet icon
   The MetaRepositary package should appear
   Click on the line and click the Install/Upgrade icon to install it
   When it is installed the status should say "Enabled"
   Click on the Retrieve List from internet icon again
   You should now see a list of packages
2. Install Dropbear from the list of packages that appeared
3. Install BackupPlanner
   To do this . . .
   Find the MetaRepository Package in the list
   Click on the Http:// link you can see on the end of that line
   find this line ftp://ftp2.zyxel.com/+
   replace it with this line http://zyxel.diskstation.eu/Users/Mijzelf/zypkg-repo/fw4_stock_packages/
   Click the Apply button
   Go back to the packages list
   Click on the Retrieve List from internet icon
   Select the BackupPlanner package
   Click on Install/Upgrade to install it
4. That's it. All done. (I had to reboot the NSA325-V2 before the Synology NAS could connect)
5. If it works, celebrate with the drink of your choice :)

Some notes on the Synology side. I used Synology's Hyper Backup. For some reason I had to choose the "single version" option. I couldn't get it to work using the "multiple versions" option, I will look into that some day. I selected rsync-compatible server, entered the IP and login credentials, Transfer encryption off, and then the storage volume of the Zyxel should appear in the dropdown for "Backup Module"

Once again thank you Mijzelf.