NWA130BE Lan Port for VLAN 2
Best Answers
-
Change PVID to "2" in your case - that should work.
0 -
Hi @George993 ,
If your access point supports a LAN port, it will be listed at the bottom of the page.
To change the LAN port settings of a specific AP, click on that AP and configure the settings.
Don't miss this great chance to upgrade your Nebula org. for free!https://bit.ly/4g2pS9L
0
All Replies
-
Change PVID to "2" in your case - that should work.
0 -
Thanks David. I use Nebula and found it as well in the AP and Port settings. Good to know where I can change it as well if I decide not to renew Nebula. I assume you have to change it for every AP when web managed? I wish there was a way in Nebula to apply it only to one AP, it changes all of them.
George
0 -
Hi @George993 ,
If your access point supports a LAN port, it will be listed at the bottom of the page.
To change the LAN port settings of a specific AP, click on that AP and configure the settings.
Don't miss this great chance to upgrade your Nebula org. for free!https://bit.ly/4g2pS9L
0
Categories
- All Categories
- 414 Beta Program
- 2.3K Nebula
- 132 Nebula Ideas
- 92 Nebula Status and Incidents
- 5.4K Security
- 181 USG FLEX H Series
- 258 Security Ideas
- 1.4K Switch
- 71 Switch Ideas
- 1K Wireless
- 37 Wireless Ideas
- 6.2K Consumer Product
- 237 Service & License
- 374 News and Release
- 79 Security Advisories
- 24 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.9K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 80 About Community
- 69 Security Highlight