-
Reinit due to HW stuck WAC6303D-S NXC2500
We have 10 WAC6303D-S AP's and a NXC2500. The log of one WAC6303D-S frequently shows the message (not an error) "Reinit due to HW stuck". I cannot find anything about the background of this, but it does not sound OK. We also have stability issues in the surroundings of this AP. Does anyone know more about this message?
-
NWA50AX adding printer
Installed my NWA50AX into my outhouse office. Perfect connect to all devices apart from my printer. Is there anyway to active WPS with it? I don’t have a cable for the printer to assist with setup.
-
Client hand-over on multiple APs
Sorry in case this topic has been already discussed. In that case a link to that thread would be highly apprecated. In our case (small company) we got an USG110 running where only one WLAN AP of type WAC6103D-I is connected to. The USG is acting as the controller for it and all is running properly. Now we rent an…
-
WAC6103d-i
My two WAC6103d-i wlan devices operating in AP mode only show a TX/RX Rate of max 54 mbit on both 2.4 (n) and 5 GHz (ac) band. Speedtests show about 25Mbit throughput only. I do not seem to be able to influence this. According to the device specification the speed should be much higher. Anyone any ideas ? i am using an…
-
CWMP ConnectionRequest 404 Not Found
Hi we have a few DEL1201-T10A devices in our private acs network , we tried to enable cwmp in device and it's connected and informed successfully . but if we tried to connect device on connectionRequest URL + connectionRequest Path , we got 404 not found error . is there any special action to make HTTP request to…
-
NWA210AX - Automatic SSH login from Openhab
Hi, i need autoconnect from Openhab to Zyxel AP, to turn on-off the wifi. I'm able to turn on-off the wifi manually with a ssh connection from my Macbook. But i'm not able from Openhab because i need to write it in a single command line like that: ssh2 -p PASSWORD USER@ZYXEL_IP /configure terminal/wlan slot1/no activate…
-
NWA50AX V6.25(ABTF.5): Where is 80 MHz @ ch132–144 and UNII-3:ch149–161?
Hello, why is the 80 MHz channel block from ch132–144 not available? This is just intangible to cut off UNII-2-Ex at ch128. What's wrong with this device? Well, and of course, where's the 80 MHz band of UNII-3:ch149–161? Btw, we're in the EU (Germany) here and I never had any radar/DFS issues (or messages about detection).…
-
Wifi 6 Release 2
With the announcement of the WiFi 6 Release 2 standard at CES......... Does the current slew of APs already support Release 2 with a software update? Namely for me the NWA210AX?
-
We have a group of 3 AP's. One is an NWA5123ACHD that is operating in limited power mode.
What can be done to correct this.
-
Firmware for UAG5100
Hello, iam searching for a new firmware for an UAG5100. Unfortunately i can't find any firmware for the UAG5100 on zyxel website: https://www.zyxel.com/de/de/products_services/Unified-Access-Gateway-UAG5100/downloads Where can i find a new firmware? Current firmware is V4.18(AAPN.0) / 2017-04-19 16:54:49 In the…
-
LTE3301-PLUS - asymmetric ping response times
Hi All, I have a Zyxel LTE3301-PLUS router. I use mobile net (300Mb) and there is a wifi intranet containing some hosts and a printer.The hosts can reach the internet with good speed via wifi. The problem occurs when I want to reach another host. The ping response time changes from 1ms to 1000ms and there is packet loss.…
-
Broadcast VLANs from Switch via WLAN [No Internet - Please Help]
Hi All, I recently received NWA50AX Access Point and would like to use this to broadcast VLANs using multi-SSID. After setup, each SSID is showing up as an available network but when a device attempts to connect there is no internet. I can connect through the router directly so I know I don't have any internet issues so I…
-
Need NWA210AX series AP support for the "Ethernet Neighbor" function.
1. There are three NWA210AX series APs. Mode - Sand alone. They have an AP function - "Ethernet Neighbor". 2. Problem - the function works strangely. When the APs connected to the usual unmanaged switch, they see each other by "Ethernet Neighbor" perfectly. 3. When APs connected to a VPN50 router or to managed switch…
-
Add support for any unicode char in SSID
Hello, An SSID can be made of any byte, 32 bytes long. Unfortunately the web interface only accept a subset of ascii char and reject any configuration file that contains anything else in the ssid. Could you add support for any UTF char in the SSID? That was something available in all my previous AP and I never get issue…
-
NWA210AX and repeater mode
I have been using one NWA210AX successfully at home for about a year, with only minor issues (like the Nintendo Switch Lite being rejected on the 2.4Ghz band with the correct passphrase but being accepted to problem on the 5Ghz, which was odd). When I moved I needed more WiFi coverage so I bought a second NWA210AX. I…
-
NWA210AX, NWA100AX, NWA50AX Antenna Propagation
Can you supply this data for me? Would be nice if this was available to download from the support page of each AP. Thanks!
-
wax610d placement
As we have no option for ceiling mount, we are considering wax510d or 610d. Or 650s but would be overkill. As there are no radiation patterns documented as yet for these devices, we are not fully sure what to advice to our customer. I have attached our scenario. We only have 2 mounting options available to cover the client…
-
deauth by Intra Roaming
Hi, I bought the AP NWA50AX, installation and configuration was relatively simple. Now I have a tablet in my network which regularly drops out and briefly loses the connection. In the AP I get the following message from the client --- "Station: 8C:83:E1:XX:XX:XX has deauth by Intra Roaming on Channel: 48, SSID: Skynet,…
-
Cannot PING devices behind NWA110AX conf in Repeater Mode
I have a NWA110AX in Root AP Mode with IP 192.168.3.61/22 and a NWA110AX in Repeater Mode with IP 192.168.3.62/22. Behind the 2nd one I have a Switch with IP 192.168.2.222/22. I can PING both APs but not the Switch. I noticed the 2nd AP has the LAN Interface in Down Status. What's missing?
-
WiFi Guests registration access via eMail
Good morning, is it possibile enable Zyxel Firewall or zyxel Access Point to manage auto registration form to grant access to the Guest WiFi via eMail authentication ? Thank you max
