NAS326 - transfer data to replacement HDD.
philr123
Posts: 4
Hi all - my NAs326 fell onto the floor and the disk drives were degraded.
I have bought two new HDD and copied all the data onto onto one of the new HDD
When I put the new backup HDD and the empty one in the NAS it seems it wants me to create a Group and lose the data. ##How do I lkeep the data and set up a new Raid 1 system
Any help appreciated!!
0
Accepted Solution
-
thanks very helpful will give it a go!
0
All Replies
-
If your old HDD has a RAID 1, you can follow these steps to replace the drives:
- Pull out one of the old HDD
- Insert one new HDD into the NAS and initiate the repair process through the NAS interface. This will pair the new HDD with the existing old HDD.
- Once the pairing is successful, remove the other old HDD from the NAS.
- Insert the second new HDD into the NAS and initiate the repair process again.
By following this procedure, you can replace the old HDDs with new ones in a RAID 1 configuration .
0 -
thanks very helpful will give it a go!
0 -
Can I replace different capacity HDDs, like from 2 of 4TB of Raid 1 to 2 of 8TB by this way, Thanks.
0
Categories
- All Categories
- 414 Beta Program
- 2.3K Nebula
- 132 Nebula Ideas
- 92 Nebula Status and Incidents
- 5.4K Security
- 181 USG FLEX H Series
- 258 Security Ideas
- 1.4K Switch
- 71 Switch Ideas
- 1K Wireless
- 37 Wireless Ideas
- 6.2K Consumer Product
- 236 Service & License
- 372 News and Release
- 79 Security Advisories
- 24 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.9K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 80 About Community
- 69 Security Highlight