Can anyone advice how to fix Co channel interference
Any articles to read is appreciated.
All Replies
-
-
Dear Customer.
There are some ways to lower the co-channel interference.
1. Channel planning: We suggest turning on the DCS feature, and setting the DCS schedule at midnight and disabling client aware to avoid serve impact. To know more about DCS configuration, please take a look at this FAQ https://community.zyxel.com/en/discussion/14121
2. Fine tune AP power: We could select the Deployment selection based on your AP deployment, or custom to set the customize power value by going to Access point >> Configure >> Radio settings >> Deployment selection & Maximum output power
3. Adjust channel width: Choose 40MHz or 20MHz instead of 80MHz to lower the co-channel interference. To configure this issue, please go to Access point >> Configure >> Radio settings >> Channel width
4. AP deployment: Well deployment can greatly improve the effective wireless transmission and reduce the error and re-transfer mission packets, we suggest using the ceiling mount and avoid shielding between AP and client.
Judy
0 -
Zyxel_Judy said:
Dear Customer.
There are some ways to lower the co-channel interference.
1. Channel planning: We suggest turning on the DCS feature, and setting the DCS schedule at midnight and disabling client aware to avoid serve impact. To know more about DCS configuration, please take a look at this FAQ https://community.zyxel.com/en/discussion/14121
2. Fine tune AP power: We could select the Deployment selection based on your AP deployment, or custom to set the customize power value by going to Access point >> Configure >> Radio settings >> Deployment selection & Maximum output power
3. Adjust channel width: Choose 40MHz or 20MHz instead of 80MHz to lower the co-channel interference. To configure this issue, please go to Access point >> Configure >> Radio settings >> Channel width
4. AP deployment: Well deployment can greatly improve the effective wireless transmission and reduce the error and re-transfer mission packets, we suggest using the ceiling mount and avoid shielding between AP and client.
0 -
To lower the co-channel interference, normally, you can adjust from 80MHz to 40MHz. If the situation is not better, then down to 20MHz.
Judy
0
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 114 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 65 Switch Ideas
- 901 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 831 Nebula FAQ
- 401 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight