-
Nr7101 poe injector protocol
My poe injector that came with the modem broke. I am looking for replacement. Is an af protocol enough or do I need an at injector? Also will an injector following both protocols work in this case ? Thanks
-
NR 7102 Remote connection
Hi im thinking if its possible to have a free service like noip in my router to login from any where easy, Because i tried with noip but didnt work Im using 5g sim so i have already always internet so i want access from anywhere.
-
NR7102 no signal 5g
I just installed the device but it does not detect signal 5g However, when I test with a mobile phone(iphone 13 pro), it detects signal 5g Why is this happening? Does it not support any frequency? The use is in Greece and the provider is cosmote
-
NR7101
Hello I'm considering purchasing a NR7101, and I had some initial setup questions, once installed I would like to use the Nr7101 in Bridge Mode and use an Asus router for Wifi is this possible? And if so how is this done?
-
Postman is not connecting
When we try to send a Get request as refered in the configuration documentaiont for the cloud managed router, it returns : "message": "404 Not Found: The requested URL was not found on the server. If you entered the URL manually please check your spelling and try again.", "status": 404} we followed all the steps in the…
-
LTE7490-M904 troubleshooting
Hi there! I just wall mounted a LTE7490-M904 in my mountain house using a SIM card by TIM (Italian ISP) and everything works fine on the control panel. I can perform ping and speed test as well with promising results. As soon as I try to configure a Google WiFi AP using the LAN cable, it detects no internet connection. I…
-
SNMP MIB for NR7101
Is there a MIB out there for the NR7101? Have enabled SNMP, and I can successfully monitor network data, but was wondering if I could als get some hardware health data.
-
NR7101 network statistics.
I have an NR7101 and when I got to the Traffic Status page the numbers I see there do not make any sense. The counter of received bytes over the WAN network reads over 1.6 TB, and this only after about 15 minutes. That is impossible. I am not pulling that much data. What is going on here?
-
Zyxel NWD7605 on Linuxmint 21.1
Hi, I've just acquired a Zyxel NWD7605 USB dongle to use it on a PC with Linuxmint 21.1 OS. I've downloaded the Linux drivers from you site, but I'm not being able to compile it with the script provided. Any special configuration I have to apply on the Makefile or any other component? Regards,
-
How to automatically reboot the NR5101 by schedule
Hi I would like to reboot my zyxel NR5101 at 05.00 AM every sunday morning. I have found some shell commands like : ***************************************************************************** As example the following for a reboot: Login into the Zywall/USG via console/telnet/SSH. Enter the following commands: configure…
-
Zyxel NR7101 Bridge Mode: Can't ping local Router from the Internet
Hello, I am setting up a new Zyxel NR7101 mobile 5G router which I ordered twice for 2 SIM card connections. I managed to get Wireguard VPN running since I'm receiving a public IPv4 address, but I can't ping my local router which is a Unifi Dream Router (UDR). My setup: Mobile connection provider is "Telekom" within…
-
How to update software correctly
Сan I update the firmware for Zyxel LTE5388-M804 immediately to the latest version or I need to be updated sequentially to previous versions?
-
NR5101 can't ping from the WAN side
Hi I have setup a NR5101 and it's working connected to a pfsense as NAT not bridge. I have the pfsense IP in the DMZ setting. Problem is I can't reach anything from the WAN side, even ping doesn't work. Supposedly having an IP in the DMZ should direct all traffic to that device unfiltered. Well, it doesn't. What could be…
-
Zyxel NWD7605 on Steam OS ( Steamdeck)
How do I install the driver and use it as a wlan interface? I am not familiar with Linux and I know how to do those steps on windows. It's just I clearly have no idea how to do it on Linux(SteamOS)
-
LTE5398-M904 disable led
it is possible to disable all the leds of the LTE5398-M904, thanks for the help (ita) è possibile disabilitare tutti i led del LTE5398-M904, grazie dell'aiuto
-
NR5103 FIRMWARE ON NR5103E: WOULD IT WORK?
Can anyone confirm if it is possible to load the NR5103 firmware on my NR5103E? Is there any risk of bricking my NR5103E? thank you
-
ZYXEL EX3301-T0 and Asus ZEN MESH
Not sure if this is the right forum as the EX3301 is not listed, however… I am about to move to an ISP that will supply an EX3301, I am currently using the ASUS ZEN AC product can I use the ASUS with the EX3301 as they are both 'MESH' device? Many thanks Phil
-
How can I add another WX3100 to a mesh of already 2
Hello, I have 2 WX3100 ap in a mesh and wanted to add another. However, no matter how I try to do this, via cable or WIFI, the 3rd WX3100 only appears as a separate access point, not part of the web. In the app it is depicted differently. Is it possible to make it part of the mesh? Also, the identification number seems to…
-
Zyxel WX3100-T0 AX1800 Mesh - Backhaul - low transfer
Hello, I bought 2x Zyxel WX3100-T0 AX1800 to create Backhaul Wi-Fi mesh network. I have a ZTE F660 router with GPON to fiber net (400/40 mbit/s) from my internet operator. ZTE should work as a client (I turned the wi-fi off in this device). 1 Zyxel WX3100 is connected by ethernet cable to ZTE and the 2nd Zyxel WX3100 is…
-
NR5103 - External Antennas can be used with 4g or 5g?
Hello i am new owner of the NR5103 i see there are 4 antenna slots on the back, at the moment in my area there is only 4G and i have 2 antennas a poynting xpol 1 4G (2x2) and a poynting xpol 2 5G (2x2) - is it possible to use these antennas on the 4g network without any problems? Thanks
